Testing my First Reloads
Welcome back to Jim’s Armory. In this one, Jim heads to the range with the very first batch of 9mm reloads to come off his new Mark 7 Apex 10 press. He hasn’t reloaded since the 90s, and back then it was straight-walled cases like .44, .357 and .45 Colt. The goal here is simple: make sure the new rounds go bang safely, then put them over a chronograph next to two factory loads to see how they stack up.
Why 9mm Is a New Challenge Jim explains that 9mm has been a bigger learning curve than the straight-walled cartridges he loaded years ago. The 9mm case is slightly tapered, so getting it to flare and expand correctly to accept a bullet, and then crimping it correctly, is new territory for him. That’s why the first ten rounds off the press are being treated as a test – and why he brought the MAC 9 DS, the “Turkato,” as the test gun. In his words, if something goes wrong, that’s not a gun he’s worried about.
First Shots: So Far, So Good The first ten rounds go off without any drama. Jim checks the results on target and is happy with what he sees. With that out of the way, it’s time to get the chronograph set up.
The Comparison Setup Jim lays out exactly what’s being tested:
- His reloads: 115 grain FMJ bullets (he doesn’t remember the bullet brand – he bought them a long time ago), CCI 500 small pistol primers, and range brass raked up from that very range and washed in the shop.
- CCI Blazer: 115 grain, plated.
- MagTech: 115 grain full metal jacket.
He runs about ten rounds of each over the chronograph so he can compare averages.
CCI Blazer Results The Blazer rounds land roughly between 1,107 and 1,151 feet per second. Along the way the Turkato throws in a malfunction, and the slide fails to lock back on an empty magazine – not a problem with the ammo, but a reminder of why this gun is getting rebuilt.
MagTech Results The MagTech loads run a bit hotter, with readings from about 1,134 up to 1,176 feet per second. The Turkato chips in a new kind of malfunction for good measure, and once again the slide doesn’t lock open at the end.
Reload Results Jim points out that he can’t really call these “hand loads,” since they came off a fully automated press – the Apex 10 with the AutoDrive. His ten rounds read between 1,044 and 1,110 feet per second, for an average of 1,081. That puts them just shy of the 1,100 mark, which is about what Jim expected and wanted for a first run.
Where the Load Goes From Here Jim started at the absolute baseline charge for this recipe, so the slower numbers make sense. He’d like to get closer to 1,200 feet per second. He also noticed the rounds were a little smoky, which he understands is expected with CFE powder, and he expects bumping the charge up a bit should clear that up.
His plan is to creep up slowly: make 50 rounds, increase the charge a little, make another 50, increase again, make another 50, then take all of them back to the range to test.
Pro-Tip: Work up a load in small steps and test each batch before moving on. Starting at the baseline charge and creeping up a little at a time is exactly how Jim is approaching it.
Lessons From the Press Things are going well with the press, and Jim has worked a lot of the kinks out. He did make some mistakes along the way – regular viewers will remember the jar of rounds he was collecting that needed to be pulled apart. He started with a tool he describes as terrible, and found a much better way: a small, inexpensive press with a pulling collet, which makes quick work of it.
Pro-Tip: If you’re pulling apart a jar of bad rounds, Jim recommends a small press with a pulling collet over the tool he started with.
Final Thoughts Jim calls the first test a big success. The reloads ran safely, came in a bit slower than factory ammo, and gave him a clear starting point for tuning the recipe. He already has more brass primed and ready to load for the next range trip – and as he puts it, mag dumping your own reloads is a lot more fun than burning through expensive factory ammo. Subscribe and stay tuned to see how the next batches do as he works up the charge.
